How to add Tun/TAP/PPP/Fuse support

NOTE: This is for new Openvz/LXC plans only.

1. You need to login to web panel and click the Active Product you want to enable it on
2. If you see "Add Tun" button, click it (if not, it is already enabled), then continue to #3 below,
3. click Stop VPS button in web panel <----- DO NOT SKIP THIS STEP!!!
4. Click Start VPS
5. SSH to your VPS and type

mkdir /dev/net
mknod /dev/net/tun c 10 200
chmod 0666 /dev/net/tun
ip tuntap add mode tap
--show it
ip link

For PPP:

mknod -m 666 /dev/ppp c 108 0
service pptp restart

To actually use a tun/tap device it must be created inside the container on every boot, so add the following to your /etc/rc.local inside your container:

if ! [ -c /dev/net/tun ]; then
mkdir -p /dev/net
mknod -m 666 /dev/net/tun c 10 200
fi

Hjälpte svaret dig?

 Skriv ut denna artikeln

Läs även

Difference between OpenVZ and LXC

OpenVZ OpenVZ is a Linux container solution. It was first released in 2005 by SWSoft, now known...

How setup OpenVPN on OpenVZ with Centos 6 64-bit template

This is only for New OpenVZ with Centos-6-OpenVPN-64-bit template. You can reinstall to this...

My Ubuntu template cannot SSH as root

If you have Ubuntu on your OpenVZ/LXC plans and you cannot login as root via SSH, it is because...

How to enable and setup RDP on Windows

NOTE: This is done on Windows 2012 DC R2 edition, other versions might be slightly different.1....

How to access Web Panel or VNC Console from Client Area (New KVM/OpenV/LXC)

NOTE: - If problems, use other web browser or try Private Window on your browser. - If you get...